POWER WINDOW CONTROL SYSTEM (for Sedan) > Driver Side Power Window does not Operate with Power Window Master Switch |
DESCRIPTION
If the manual UP / DOWN and AUTO DOWN functions do not operate, a malfunction may exist in the power window regulator master switch, power window regulator motor or wire harness.WIRING DIAGRAM
INSPECTION PROCEDURE
1.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (DRIVER SWITCH) |
Remove the power window regulator master switch assembly.
Measure the resistance of the switch when the switch is operated.
- Standard resistance:
Window Lock Switch Condition Power Window Switch Condition Tester Connection Specified Condition Always
(ON / OFF)UP 1 (E) - 4 (D)
3 (U) - 6 (B)Below 1 Ω Always
(ON / OFF)OFF 1 (E) - 3 (U)
1 (E) - 4 (D)Below 1 Ω Always
(ON / OFF)DOWN 1 (E) - 3 (U)
6 (B) - 4 (D)Below 1 Ω Always
(ON / OFF)AUTO DOWN 1 (E) - 3 (U)
6 (B) - 4 (D)Below 1 Ω
Reinstall the power window regulator master switch assembly.
|
| ||||
OK | |
2.CHECK HARNESS AND CONNECTOR (MASTER SWITCH - MOTOR (DRIVER SIDE)) |
Disconnect the G1 power window regulator master switch assembly connector.
Disconnect the G4 power window regulator motor assembly connector.
Measure the resistance of the wire harness side connectors.
- Standard resistance:
Tester Connection Specified Condition G1-4 (D) - G4-1 Below 1 Ω G1-3 (U) - G4-2 Below 1 Ω G1-4 (D) or G4-1 - Body ground 10 kΩ or higher G1-3 (U) or G4-2 - Body ground 10 kΩ or higher
Reconnect the G1 power window regulator master switch assembly connector.
Reconnect the G4 power window regulator motor assembly connector.
|
| ||||
OK | |
3.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY (DRIVER SIDE) |
Remove the power window regulator motor assembly.
Apply battery voltage to connector terminals 1 and 2.
- NOTICE:
- Do not apply battery voltage to any terminals except terminals 1 and 2.
Check that the motor gear rotates smoothly as follows.
- OK:
Measurement Condition Specified Condition Battery positive (+) → 1
Battery negative (-) → 2Motor gear rotates counterclockwise Battery positive (+) → 2
Battery negative (-) → 1Motor gear rotates clockwise
Reinstall the power window regulator motor assembly
|
| ||||
OK | ||
|