FRONT LOWER SUSPENSION ARM (for Hatchback LH Side) > INSTALLATION |
1. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH |
Provisionally tighten the front lower suspension arm sub-assembly LH with the 2 bolts.
Install the front lower suspension arm sub-assembly LH onto the steering knuckle with a new castle nut.
- Torque:
- 98 N*m{ 999 kgf*cm , 72 ft.*lbf }
- NOTICE:
- If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
Install a new clip.
2. INSTALL FRONT WHEEL |
- Torque:
- 103 N*m{ 1050 kgf*cm , 76 ft.*lbf }
3. STABILIZE SUSPENSION |
Lower the vehicle from the jack.
Bounce the vehicle up and down several times to stabilize the suspension.
4. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH |
Fully tighten the 2 bolts.
- Torque:
- Bolt A:
- 137 N*m{ 1397 kgf*cm , 101 ft.*lbf }
- Bolt B:
- 151 N*m{ 1540 kgf*cm , 111 ft.*lbf }
5. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT |