SRS SEAT CUSHION AIRBAG ASSEMBLY (for Hatchback) > INSTALLATION


CAUTION:
  1. Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).
  2. If the cushion airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.
  3. Wear protective gloves. Sharp areas on the parts may injure your hands.

NOTICE:
Always use "TORX" socket wrench E10 when removing the front seat.

HINT:
The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.


1. INSTALL SRS SEAT CUSHION AIRBAG ASSEMBLY

CAUTION:
  1. The nuts must not be reused.
  2. Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.

  1. Install the SRS seat cushion airbag assembly with new 3 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Engage the clamps to install the SRS seat cushion airbag wire harness.



2. INSTALL SEAT CUSHION COVER WITH PAD


  1. Engage the 5 hooks to install the seat cushion cover with pad to the separate type front seat cushion spring assembly.


    B332528



    B332533

  1. Engage the 2 hooks.



    B290038

  1. Engage the 3 clamps to install the front seat airbag wire harness. (w/ Front Seat Side Airbag)



    B272761

  1. Engage the 4 hooks.



    B289256

  1. Fasten the hook and loop fastener. (w/ Front Seat Side Airbag)



    B332511

  1. Connect the seatback cover band.

  1. Engage the 2 hooks.



3. INSTALL FRONT SEAT CUSHION INNER SHIELD LH


    B283230

  1. Engage the 2 claws to install the front seat cushion inner shield.



4. INSTALL FRONT SEAT CUSHION SHIELD LH


    B283229

  1. Engage the clip and 2 claws to install the front seat cushion shield.

  1. Install the screw.



5. INSTALL VERTICAL ADJUSTING HANDLE LH (w/ Vertical Adjuster)


    B283228

  1. Install the vertical adjusting handle with the screw.



6. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH


    B332529

  1. Engage the claw to install the reclining adjuster release handle.



7. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)
(Click here)


8. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)
(Click here)


9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


10. INSPECT SRS WARNING LIGHT
(Click here)