STEERING WHEEL (for Sedan) > INSTALLATION

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).


1. ADJUST SPIRAL CABLE


    C121534
  1. Center the spiral cable.

    1. Turn the spiral cable counterclockwise until it locks.

      HINT:
      The spiral cable turns a maximum of approximately 5 times.


    2. C121533E01
    3. Turn the spiral cable 2.5 times clockwise from its locked position and align the center marks.



2. INSTALL STEERING WHEEL ASSEMBLY


    C139086E01
  1. Align the matchmarks and install the steering wheel assembly onto the steering column assembly.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }
  1. Connect all connectors to the spiral cable.



3. INSTALL STEERING PAD


C137497E01

NOTICE:
Do not use a steering pad that has been dropped.
  1. Confirm that the ignition switch is turned to OFF.

  1. Confirm that the negative battery terminal is detached.

    CAUTION:
    Do not begin the operation for at least 90 seconds after the negative battery terminal is detached.
  1. Connect the horn terminal.

  1. Connect the airbag connector.

    NOTICE:
    1. Match the color of the airbag connector with that of the steering pad assembly, and install the airbag connector.
    2. Securely lock the locking button.


    C140450
  1. Install the steering pad.

  1. Using "Torx" socked wrench T30, tighten the 2 bolts.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }

    NOTICE:
    Tighten the 2 bolts while holding the steering pad to prevent it moving upward.


4. POSITION FRONT WHEELS FACING STRAIGHT AHEAD


5. CHECK SRS WARNING LIGHT
(Click here)